The Antminer D3 is Bitmain's ASIC miner for the X11 hashing algorithm. X11 is growing in popularity so it is natural that the larger hardware manufacturer of crypto-currency miners has decided to enter the market with their commercial offering. The D3's design is in the same line of all the Antminers since the S7 miner. The length is very close the S9 miner. The miner has the same configuration of: three hashing boards, controller board, two fans and an aluminum case. The units is a little higher than an S9 but outside of that, basically the same.
The web interface is the same Linux powered setup you find in all of the Bitmain offerings. There are five mineable coins for the X11 protocol. DASH by far is the coin that almost everyone is mining with these units. With the growing popularity of this miner, we could see the difficult spike significantly when this launch. Each units takes 1,200 watts a piece. On a 20-amp you can safely run two miners and potentially three miners but please note you will be 1.3 amps over the normal de-rating of 80% of the breakers maximum capacity.
Overall another solid offering from Bitmain and should do a good job mining for X11.
Model Antminer D3 (15Gh/s)
Release Date September 2017
Size 5.11 x 7.48 x 12.59 inches
Noise level 75db
Power 1200 watts
Wires 9 * 6pins PCIE
Voltage 11.60 ~13.00 volts
Temperature 60 - 95 °F
Humidity 5 - 80%